AUTOMOTIVE PAINT

          
This is a polyurethane based enamel that is very easy to use for basic automotive,
truck, motorcycle, and machinery jobs.
 Can be brushed, rolled or sprayed.
 Re coat time is 2 4 hours depending on weather conditions.
 Thinning and clean up use mineral turps only.

PREPARATION
 Can be painted onto most solid pre painted surfaces. Remove all oxidation, oils
etc. then key sand off and do a small test patch first on the prepared surface to
compare compatibility.
 Bare steel should be undercoated with crystal red or grey oxide zinc chromate
primer.
 Motorcycle plastic fairings can be sanded lightly and applied straight on.
 Automotive plastics and fiberglass can be applied straight on after a fine sand.
 Colours available white, blue, black, yellow, golden yellow, red and many lighter
colours.
 Do not mix with any other paints, solvents or additives as this could effect the
performance of the paint.
 Coverage is 10-12 square metres per litre.

WHAT ELSE DO I NEED TO KNOW?
1. If you're going to spray, you will need to thin the paint out about 5-10%
mineral turps or more depending on your spray unit.
2. Do not paint if the temperature is less then 12 degrees C.

AVAILABLE IN 1 AND 4 LITRE CANS